To the right of the blade, when fully extended, you get 24.5 inches of rip capacity, that’s easy enough to handle four by eight sheets of OSB of plywood. Making this a fantastic choice for those doing cabinetry, though, for those doing large cabinetry, this could be a challenge for the DeWalt DWE7485.

The DWE7485 has a 5/8-inch arbor which is a common size, so a wide variety of table saw blades will be compatible. Dust Collection DW745 model has been replaced by DWE7485 but is still used by many. It was replaced as it didn’t have a 10-inch blade anymore even though it features the same as a DWE7491. Can You Add A Dado To A Dewalt Dwe7485?A secondary dust port is located under the table saw. This is a larger opening that is designed to handle shop-sized dust extraction hoses. You will probably have less interference from this port than from the one mounted on the top. 5. Safety components Apart from this, I will let you know what features attracted me and the few aspects of this product that let me down. If you’re not sure who this product was designed for, I will let you know the people for whom this saw is a perfect verdict. The table saw uses a rip fence to keep lumber aligned and straight during the cut. Both circular and miter saws need alignment with each pass and stops for repeated cuts. Saw guides can be time-consuming to set up for additional cuts, while a table saw can make the same cut again and again.

This model might not be the best choice for those looking to work with larger pieces, as the fence extension on this model is limited to medium-length workpieces. These basic safety features ensure that you are safe from the saw blade, as DeWalt knows that if it’s difficult or time-consuming to adjust the safety features, then people just won’t use them on the DeWalt dwe7485 table saw. This table saw is not only a compact size, but it’s also lightweight; it weighs only 46 pounds; this is a huge bonus as it’s incredibly easy for one person to carry it around. But to save weight, some features and materials were left off of the design. Table and Rails

It has a dust port that measures 2 1/2-inches. That will fit many shop vacs, and you should be able to source a conversion kit that will fit it if necessary. Keep an eye on the hose as it can interfere with the riving knives if it is pulled too tightly.